Click to enlarge

PA522 120/240V Power Transformer for Dyna PAS Dynaco Replacement MADE IN USA (DISCONTINUED)

*********DISCONTINUED**********
PA522 Upgrade and Replacement Universal 120/240V transformer for Dynaco PAS2, PAS3 and PAS3X preamplifiers. Direct bolt in replacement-no drilling or cutting required to install. New unit, MADE IN USA by transformer professionals with decades of experience manufacturing high voltage transformers. Guaranteed to meet or exceed published specifications for the original Dynaco unit. Of course you can use these for do-it-yourself preamp projects, it will power up to 4 12AX7/ECC83 or similar tubes. You could build a nice buffer preamp or mic pre. For guitar you could build a fender front end clone. Check out our reverb transformer and a twin reverb schematic for your tube reverb project.

Runs cooler, regulates better than original due to improved insulation technology that allows larger gauge secondary wire, resulting in more than 50% less copper resistance on the secondary than the original. Secondary is 330-0-330VAC at 15 ma DC rectified current, plus 12V at 800ma for filaments & pilot lamp. Primary is dual 120/240VAC 50/60 Hz.

Transformer is 2 1/4 inch high by 2 inch wide by 2 1/4 inch deep over the end bells.


PA522$119.95

Wiring Diagram


Triode, USA
Customer Service
M-F 9AM-4PM CT 1-800-774-3201
Email us Anytime: questions@triodestore.com